Chapter 16 Engineering Setup
266
Setup Relating to Operations From the Control Panel
To select a destination selection button for a snapshot
Note
This setting is disabled for the CCP-9000.
To set whether snapshots are recalled for each destination selection button
individually, use the RTR Mode Setting menu as follows.
1
Use any of the following methods to select the destination selection button
to which the setting applies.
• Press directly on the list on the left of the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
2
Press [SS Enable], turning it on or off.
On: When a snapshot applying to the router is recalled, the recall also
applies to the selected destination selection button.
Off: When a snapshot applying to the router is recalled, the recall does not
apply to the selected destination selection button.
Note
When a destination selection button is set to Inhibit, then even if SS Enable
is on, the snapshot for that destination is not recalled.
Setting Button Assignments (Prefs/Utility Menu)
To assign functions to the user preference buttons ([PREFS 1] to [PREFS 8])
in the menu control block and the memory recall buttons in the utility/shotbox
control block, display the Panel>Prefs/Utility menu.
To display the Prefs/Utility menu
In the Engineering Setup menu, select VF2 ‘Panel’ and HF4 ‘Prefs/Utility.’
The status area shows the settings of the user preference buttons.
Assigning functions to user preference buttons
Use the following procedure.
Knob Parameter Adjustment Setting values
1 Dest No Selection of destination selection
button
1 to 64
To Next Page
Loading...
