267Setup Relating to Operations From the Control Panel
Chapter 16 Engineering Setup
1
Using any of the following methods, select the button to be assigned.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
2
In the <Action> group, select the function to be assigned.
Menu Shortcut: Assign a frequently used menu to be recalled (menu
shortcut).
Utility Command: Assign a function enable/disable or similar operation
(utility command).
Shotbox Recall: Assign a shotbox register recall.
3
Depending on the selection in step 2, make the following settings.
When Menu Shortcut is selected: For the subsequent operations, see the
next item “Assigning a menu shortcut to a user preference button”
(page 270).
When Utility Command is selected: A list of commands appears on the
right of the status area; using any of the following methods, select the
command you want to assign.
• Press directly on the list.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
When Shotbox Recall is selected: Turn the knob to select the shotbox
register you want to assign.
4
Press [Action Set].
This assigns the selected action, which is reflected in the status area.
To cancel an assignment
After selecting the relevant button, press [Clear].
List of utility commands and user preference button status
The following table shows the utility commands that can be assigned to user
preference buttons.
Knob Parameter Adjustment Setting values
1 No User preference button selection 1 to 8
Knob Parameter Adjustment Setting values
3 Command Utility command selection 1 to ...
Knob Parameter Adjustment Setting values
3 Shotbox Shotbox register selection 1 to 99
To Next Page
Loading...
