Chapter 11 DME Operations
90
DME Special Effect Operations
Lighting Settings
This effect provides the effect of light striking the image. The following
lighting patterns are available:
•Plane
•Bar
• Preset (lighting pattern suitable for nonlinear effects)
Note
You cannot select Bar for an image subjected to a nonlinear effect.
Applying the Lighting effect
Use the following procedure.
1
In the DME menu, select VF5 ‘Light/Trail’ and HF1 ‘Lighting.’
The Lighting menu appears.
2
Press [Lighting], turning it on.
The Lighting effect is enabled.
3
In the <Light Pattern> group, select the lighting pattern Plane, Bar or
Preset.
You can adjust the intensity of the light and other parameters with the
knobs.
4
Set the parameters.
The parameters differ as follows, depending on the selected lighting
pattern.
• When Plane is selected
a) You can make the Lighting effect more effective by adjusting [Total Ambient] to lower the
brightness of the entire image. This setting is used both by this effect and by the
Spotlighting effect.
• When Bar is selected
Knob Parameter Adjustment Setting values
1 Light Intensity of light in highlight area 0.00 to 100.00
5 Total Ambient Brightness of whole image
0.00 to 100.00
a)
Knob Parameter Adjustment Setting values
1 Light Intensity of light in highlight area 0.00 to 100.00
To Next Page
Loading...
