341Setup Relating to Router Interface and Tally
Chapter 16 Engineering Setup
Tally Group Settings (Group Tally Menu)
With the S-Bus protocol, tally control is possible for groups 1 to 8, but in this
system you can use either groups 1 to 4 or groups 5 to 8.
You can also select whether or not to transfer the tally information over the S-
Bus.
To select the tally groups, use the Router/Tally>Group Tally menu.
To display the Group Tally menu
In the Engineering Setup menu, select VF6 ‘Router/Tally’ and HF2 ‘Group
Tally.’
Setting the tally groups
Use the following procedure.
1
In the <Tally Group> group of the Group Tally menu, select the tally
groups.
Group1 to 4: Use groups 1 to 4.
Group5 to 8: Use groups 5 to 8.
2
Press [SBus Tally Enable], turning it on or off.
On: Enable the transfer of S-Bus tally information over the S-Bus.
Off: Disable the transfer of S-Bus tally information over the S-Bus.
Wiring Settings (Wiring Menu)
When configuring a system in which the switcher inputs and outputs are
connected to a router, it is necessary to set this connection configuration
(referred to as “wiring”) in the S-Bus space.
To make the wiring settings, use the Router/Tally>Wiring menu. The settings
are common to the parallel and serial tallies.
To display the Wiring menu
In the Engineering Setup menu, select VF6 ‘Router/Tally’ and HF3 ‘Wiring.’
The status area shows the wiring settings.
Making new wiring settings
Use the following procedure.
To Next Page
Loading...
