Chapter 17 Files
358
Operations on Individual Files
• To select a single file, press the arrow keys to scroll the reverse video
cursor, or press directly on the list in the status area.
5
Press [t Save].
This saves the selected register data in the specified location.
If there is already data in the specified location, a confirmation message
appears.
• Select “Yes” to overwrite the data.
• Select “No” to cancel saving all of the data.
Loading Files
As an example, to load a snapshot file from hard disk or memory card to a
register, use the following procedure.
1
In the File menu, select VF3 ‘Snapshot’ and HF1 ‘Snapshot.’
2
In the device selection area on the left, select [Register].
3
In the device selection area on the right, select where the file is held
([HDD] or [Memory Card]), and then specify a directory.
See “Selecting a Device for Operations” (page 356).
4
Using any of the following methods, select the register to which you want
to load, and the file to be loaded.
• To select all files within the list, press [ALL] below the list.
• To select multiple files, turn the knobs to select in the following ranges.
• To select a single file, press the arrow keys to scroll the reverse video
cursor, or press directly on the list in the status area.
3 Num Number of registers to be selected 1 to 99
Knob Parameter Adjustment Setting values
Knob Parameter Adjustment Setting values
1 List L Select the first register into which the data
is to be loaded
1 to 99
2 List R Select the first file in which data is held 1 to 99
3 Num Number to be selected 1 to 99
To Next Page
Loading...
