Sony DVS-9000SF - Beveled Edge Settings

Chapter 11 DME Operations
28
DME Special Effect Operations
4 To soften the edges of the image, press [Edge Soft], turning it on, and set
the following parameter.
Note
Edges cannot be softened when the Crop effect is disabled.
Beveled Edge Settings
This effect applies a beveled frame appearance to an image.
For sample images, see “DME Special Effects” in Chapter 1 (Volume 1).
Applying a beveled edge
Use the following procedure.
1 In the DME menu, select VF1 ‘Edge’ and HF2 ‘Beveled Edge.’
The Beveled Edge menu appears.
2 Press [Beveled Edge], turning it on.
This enables the beveled edge, and you can now use the knobs to adjust the
parameters.
Note
When the border is enabled, the edge soft function (see page 28) is not
available.
Parameter group [2/2]
Knob Parameter Adjustment Setting values
1 Top Crop position on top side –2.25 to +2.25
2 Left Crop position on left side –4.00 to +4.00
3 Right Crop position on right side –4.00 to +4.00
4 Bottom Crop position on bottom side –2.25 to +2.25
Knob Parameter Adjustment Setting values
1 Soft Softness of edges 0.00 to 100.00