27DME Special Effect Operations
Chapter 11 DME Operations
Cropping the image
Use the following procedure.
1
In the DME menu, select VF1 ‘Edge’ and HF1 ‘Border/Crop.’
The Border/Crop menu appears.
2
Press [Crop], turning it on.
The Crop effect is enabled. You can adjust degree of cropping with the
knobs.
3
Set the parameters.
The valid ranges of the parameter values depend on the aspect ratio (4:3/
16:9) selected in the system, as follows.
•4:3 mode
• 16:9 mode
Parameter group [1/2]
Knob Parameter Adjustment Setting values
1 H Crop positions on left and right
sides
Left value shown
2 V Crop positions on top and
bottom sides
Top value shown
3 All Crop positions on all sides Left value shown
Parameter group [2/2]
Knob Parameter Adjustment Setting values
1 Top Crop position on top side –3.00 to +3.00
2 Left Crop position on left side –4.00 to +4.00
3 Right Crop position on right side –4.00 to +4.00
4 Bottom Crop position on bottom side –3.00 to +3.00
Parameter group [1/2]
Knob Parameter Adjustment Setting values
1 H Crop positions on left and right
sides
Left value shown
2 V Crop positions on top and
bottom sides
Top value shown
3 All Crop positions on all sides Left value shown
To Next Page
Loading...
