Sony DVS-9000SF - Keyframe Strobe Settings

99DME Special Effect Operations
Chapter 11 DME Operations
1 Press the [DUST] button, turning it on.
2 Set the following parameters.
a) The way in which the afterimage disappears is affected by both the Video Decay and
Decay Dust parameter adjustments for the motion decay.
Keyframe Strobe Settings
Each time a keyframe is passed, the video image is frozen, and left remaining.
Note
When you turn on keyframe strobe, if the Trail or Motion Decay effect is on, it
automatically goes off.
Leaving a trail of afterimages of the image
Use the following procedure.
1 In the DME menu, select VF5 ‘Light/Trail’ and HF4 ‘KF Strobe.’
The KF Strobe menu appears.
2 Press [KF Strobe], turning it on.
This enables the Keyframe Strobe effect, and you can now use the knobs
to adjust the parameters.
3 Set the following parameter.
a) At the setting 0.00, there is no afterimage. At a setting of 100.00, the afterimage does not
decay.
Knob Parameter Adjustment Setting values
1 Decay Dust Amount of the afterimage
disappearing as stardust
a)
0.00 to 100.00
2 Dust Soft Timing with which stardust
disappears
0.00 to 100.00
3 Dust Size Size of stardust 0.00 to 100.00
4 Dust Aspect Aspect ratio of stardust –100.00 to +100.00
Knob Parameter Adjustment Setting values
1 Decay Degree of blurring of the video
signal
0.00 to 100.00
a)