213Snapshot Operations in the Menus
Chapter 14 Snapshots
When an effect dissolve is set:
When an auto transition is set:
When a GPI output is set:
Setting Key Snapshot Attributes
Applying key snapshot attributes
To apply an attribute to a key snapshot, use the following procedure.
1
In the Snapshot menu, press VF5 ‘Key Snapshot’ and HF1 ‘Attribute.’
The Snapshot>Key Snapshot>Attribute menu appears.
The status area shows the region names, register numbers, and whether the
registers are locked or not.
Fk Cross-point hold is set for the DME front key bus.
Bv Cross-point hold is set for the DME back video bus.
Bk Cross-point hold is set for the DME back key bus.
Aux Cross-point hold is set for one of the AUX buses.
Mon Cross-point hold is set for one of the monitor buses.
Fm1, Fm2 Cross-point hold is set for one of the frame memory 1 and 2
buses.
RTR Cross-point hold is set for the Router region.
Displayed
character codes
Attributes set
Duration value The effect dissolve attribute is set, with the displayed duration.
Displayed
character codes
Attributes set
T Auto transition is set.
Displayed
character codes
Attributes set
Port number GPI output is set for the port of the displayed number.
Displayed
character codes
Attributes set
To Next Page
Loading...
