Chapter 14 Snapshots
212
Snapshot Operations in the Menus
To apply the auto transition attribute
Press [Auto Transition], turning it on.
To apply the GPI output attribute
1
Press [GPI Output], turning it on.
2
Turn the knob to set the port number.
For details of attributes and available attributes, see “Snapshots” in Chapter
1 (Volume 1).
Snapshot Status Display
The Snapshot>Attribute menu displays the following information.
For details of how to access the Snapshot>Attribute menu, see page 210.
Region name: The selected region name appears in the upper part of the list.
Register number
Register name
Write-protected status: When the register is write-protected, an “L” (for
“lock”) appears.
Empty status: When the register is empty, an “E” (for “empty”) appears.
Attribute settings: The attributes set for a register are shown by the following
character codes.
When the cross-point hold is set:
Knob Parameter Adjustment Setting values
5 Temp Dur Temporary attribute
dissolve duration
0 to 999 (frames)
Knob Parameter Adjustment Setting values
4 GPI Out
Port
GPI output port number 1 to 8
Displayed
character codes
Attributes set
A, B Cross-point hold is set for the A or B background bus.
1, 2, 3, 4 Cross-point hold is set for key bus 1, 2, 3, or 4.
U1, U2 Cross-point hold is set for the utility 1 or utility 2 bus.
Fv Cross-point hold is set for the DME front video bus.
To Next Page
Loading...
