Sony DVS-9000SF - Page 211

211Snapshot Operations in the Menus
Chapter 14 Snapshots
5 In the <Attribute> group, press the buttons for the attributes you want to
apply, turning them on.
Carry out the following procedures for each of the attributes.
To apply the cross-point hold attributes
1 Press [XPT Hold].
The Snapshot>Attribute>Xpt Hold menu appears. The status area shows a
list of the currently selected regions and bus names.
2 Using either of the following methods, select the register.
• Press directly on the list in the status area. To select one or more buses,
press [Plural] and then select buses.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knobs.
a) Appears when the region is other than RTR.
b) Appears when the region is RTR.
• To select all registers, press [ALL].
3 Press [On].
This enables cross-point hold on the selected bus or buses.
To switch cross-point hold off, press [Off].
To apply the effect dissolve attribute
1 Press [Effect Dissolve], turning it on.
2 Turn the knob to set the effect dissolve duration.
To set the duration for a dissolve set as a temporary attribute
effect
To set the duration for a dissolve set as a temporary attribute effect in the
numeric keypad control block, turn the knob.
Knob Parameter Adjustment Setting values
3
Bus
a)
Bus name selection –
3
Destination
b)
Destination selection –
Knob Parameter Adjustment Setting values
3 Eff Diss Duration Dissolve duration 0 to 999 (frames)