399Color Corrector Functions
Chapter 19 Color Corrector
5
In the <Luminance Process Adjust> group, press [Dark], [Mid], or
[Bright], and adjust the following parameters for the three regions.
• In tint mode
• In color modify mode
To return the parameters to their default settings
In the <Luminance Process> group, press [Unity].
Masking a part of luminance processing
In the <Luminance Mask> group, press [Mask1] or [Mask2], turning it on, then
carry out the same procedure as in “Masking a part of the primary color
correction” (page 393).
Spot Color Adjustment
Note
When secondary color correction is enabled in the setup settings, this function
is disabled. (See “Switching the color correction function” (page 244).)
Adjusting the color of the specified region (key)
Use the following procedure.
1
In the CCR menu, press VF1 ‘CCR1’ and HF6 ‘Spot CCR/Output.’
The Spot CCR/Output menu appears.
2
In the <Spot CCR> group, press [Spot CCR], turning it on.
3
In the <Auto> group, press [Sample Mark], turning it on.
Knob Parameter Adjustment Setting values
1 Luminance Luminance –100.00 to +100.00
2 Saturation Saturation 0.00 to 100.00
3 Hue Hue 359.99 to 0.00
Knob Parameter Adjustment Setting values
1 Luminance Luminance –100.00 to +100.00
2 C Gain Chrominance signal gain 0.00 to 200.00
3 Hue Delay Hue delay –180.00 to +180.00
To Next Page
Loading...
