Chapter 19 Color Corrector
400
Color Corrector Functions
Note
When [Sample Mark] is on, the effects of color adjustment outside the
region of spot color adjustment (see page 401) and output video processing
(see page 401) are temporarily disabled.
Turning [Sample Mark] off restores the former state.
4
Adjust the parameters so that the color you want to change is included
within the sample mark.
5
In the <Auto> group, press [Auto Start], to adjust the key automatically.
Note
This automatic adjustment does not carry out key gain adjustment. If
required, adjust the key gain as shown in step 6.
6
Press [Key Adjust], and adjust the following parameters.
7
Press [Window], turning it on, to adjust the key detection range for spot
color adjustment.
8
In the <Spot CCR> group, press [Spot CCR] to display the parameters, and
adjust the replacement color
.
Knob Parameter Adjustment Setting values
1 Position H Horizontal position –100.00 to +100.00
2 Position V Vertical position –100.00 to +100.00
3 Size Size 1.00 to 100.00
Knob Parameter Adjustment Setting values
1 Luminance Luminance –7.30 to +109.58
2 Saturation Saturation 0.00 to 100.00
3 Hue Hue 359.99 to 0.00
4 Gain Key gain –100.00 to +100.00
Knob Parameter Adjustment Setting values
1 Luminance Luminance 0.00 to 100.00
2 Saturation Saturation 0.00 to 100.00
3 Hue Hue 0.00 to 100.00
Knob Parameter Adjustment Setting values
1 Luminance Luminance 0.00 to 100.00
To Next Page
Loading...
