61DME Special Effect Operations
Chapter 11 DME Operations
5
To invert the mask source, press [Invert], turning it on.
6
As required, set the modifiers for the mask pattern.
• When turning [Aspect] on and adjusting the pattern aspect ratio
a) When a minus value is specified, the picture is extended in the vertical direction. When a
plus value is specified, the picture is extended in the horizontal direction.
• When turning [Angle] on in the <Rotation> group and slanting the
pattern
a) –1.00 is one rotation in counterclockwise direction.+1.00 is one rotation in clockwise
direction. 0.00 is no rotation.
• When turning [Speed] on in the <Rotation> group and rotating the
pattern at a specified speed
a) –100.00 is four rotations per second in counterclockwise direction.+100.00 is four
rotations per second in clockwise direction. 0.00 is no rotation.
Freeze Settings
This effect freezes the input video. The following types are available:
• Hard Freeze
• Time Strobe
• Film
For details of the operation modes, see “DME Special Effects” in Chapter 1
(Volume 1).
To apply a Freeze effect, start by displaying the Freeze menu. In the DME
menu, select VF3 ‘Freeze’ and HF1 ‘Freeze.’
Applying the Hard Freeze effect
Use the following procedure.
1
In the <Freeze Timing> group, select the signal freeze timing.
Knob Parameter Adjustment Setting values
1 Aspect Aspect ratio
–100.00 to +100.00
a)
Knob Parameter Adjustment Setting values
1 Angle Rotation angle of pattern
–8.00 to +8.00
a)
Knob Parameter Adjustment Setting values
1 Speed Rotation speed of pattern
–100.00 to +100.00
a)
To Next Page
Loading...
