187Executing Effects
Chapter 13 Keyframe Effects
Executing an effect automatically
Use the following procedure.
1
Select the region in which you want to execute the effect, using the region
selection buttons in the numeric keypad control block. (See step 2 (page
162) of “Recalling a register.”)
2
With the numeric keypad, enter the number of the register in which the
effect you want to execute is saved, and press the [ENTER] button to
confirm.
This recalls the effect saved in the register.
3
In the keyframe control block, press the [RUN] button.
The [RUN] button lights amber and the effect is executed automatically.
Moving to the first keyframe of the effect
To move to the first keyframe of the effect, press the [REWIND] button.
Setting the Run Mode
You can set the run mode in which an effect is executed when you press the
[RUN] button.
Specifying the effect execution direction
To specify the effect execution direction, press the [REV] button, turning it on
(for reverse direction) or off (for normal direction).
To execute the effect so as to alternate the normal and reverse directions, press
the [NORM/REV] button, turning it on.
When the [REV] button is off: The effect is executed in the direction from
the first keyframe to the last keyframe.
When the [REV] button is on: The effect is executed in the direction from the
last keyframe to the first keyframe.
When the [NORM/REV] button is on: Each time the effect is executed, the
direction reverses.
Executing an effect up to the next keyframe
Use the following procedure.
To Next Page
Loading...
