Chapter 11 DME Operations
26
DME Special Effect Operations
• 16:9 mode
4
To set the border color and density, press [Border Color], turning it on, and
set the following parameters.
5
To soften the border edges, press [Border Soft], turning it on, and set the
following parameters.
Crop Settings
This effect crops the image.
For an illustrative figure and other information, see “DME Special Effects” in
Chapter 1 (Volume 1).
Parameter group [1/2]
Knob Parameter Adjustment Setting values
1 H Border width on left and right
sides
Left value shown
2 V Border width on top and bottom
sides
Top value shown
3 All Border width on all sides Left value shown
5 Density Border density 0.00 to 100.00
Parameter group [2/2]
Knob Parameter Adjustment Setting values
1 Top Border width on top side –4.50 to +4.50
2 Left Border width on left side –8.00 to +8.00
3 Right Border width on right side –8.00 to +8.00
4 Bottom Border width on bottom side –4.50 to +4.50
5 Density Border density 0.00 to 100.00
Knob Parameter Adjustment Setting values
1 Luminance Luminance 0.00 to 100.00
2 Saturation Saturation 0.00 to 100.00
3 Hue Hue 359.99 to 0.00
Knob Parameter Adjustment Setting values
1 Soft Softness of inner side of border 0.00 to 100.00
To Next Page
Loading...
