Sony DVS-9000SF - Page 25

25DME Special Effect Operations
Chapter 11 DME Operations
For an illustrative figure and other information, see “DME Special Effects” in
Chapter 1 (Volume 1).
Adding a border
Use the following procedure.
1 In the DME menu, select VF1 ‘Edge’ and HF1 ‘Border/Crop.’
The Border/Crop menu appears.
2 Press [Border], turning it on.
The Border effect is enabled. You can adjust the border width parameters
with the knobs.
Note
Once the Border effect is enabled, you cannot use the Edge Soft effect (see
page 28).
3 Set the parameters.
The valid ranges of the parameter values depend on the aspect ratio (4:3/
16:9) selected in the system, as follows.
•4:3 mode
Parameter group [1/2]
Knob Parameter Adjustment Setting values
1 H Border width on left and right
sides
Left value shown
2 V Border width on top and bottom
sides
Top value shown
3 All Border width on all sides Left value shown
5 Density Border density 0.00 to 100.00
Parameter group [2/2]
Knob Parameter Adjustment Setting values
1 Top Border width on top side –6.00 to +6.00
2 Left Border width on left side –8.00 to +8.00
3 Right Border width on right side –8.00 to +8.00
4 Bottom Border width on bottom side –6.00 to +6.00
5 Density Border density 0.00 to 100.00