31DME Special Effect Operations
Chapter 11 DME Operations
Note
When key borders are enabled, the Glow function (see page 58) is not
available.
3
Set the following parameters.
4
To set the key border color, press [Flat Color] and adjust the following
parameters.
To select an outline only key
Press [Outline], turning it on.
The outline only effect is enabled.
Art Edge Settings
This effect adds edges to the inside and outside of the input picture.
Applying art edges
Use the following procedure.
1
In the DME menu, select VF1 ‘Edge’ and HF4 ‘Art Edge.’
The Art Edge menu appears.
Knob Parameter Adjustment Setting values
1 H Simultaneously adjust width of left
and right key borders
0.00 to 100.00
2 V Simultaneously adjust width of top
and bottom key borders
0.00 to 100.00
3 All Simultaneously adjust width of all
four key borders
Value of H shown
4 Soft Softness of the key borders 0.00 to 100.00
5 Density Density of the key borders 0.00 to 100.00
Knob Parameter Adjustment Setting values
1 Luminance Luminance 0.00 to 100.00
2 Saturation Saturation 0.00 to 100.00
3 Hue Hue 359.99 to 0.00
To Next Page
Loading...
