Sony DVS-9000SF - Tally Copy Settings (Tally Copy Menu)

345Setup Relating to Router Interface and Tally
Chapter 16 Engineering Setup
2 With reference to steps 2 to 5 in the preceding section “Making new tally
generation settings,” change the parameters as required.
3 Press [Execute].
This modifies the tally generation settings.
Deleting tally generation settings
Use the following procedure.
1 Using either of the following methods in the Router/Tally Enable menu,
select the tally generation entry you want to delete.
• Press directly on the list appearing in the status area.
• Press the arrow keys to scroll the reverse video cursor.
2 Press [Delete].
This deletes the selected tally generation entry.
Tally Copy Settings (Tally Copy Menu)
For settings relating to the tally copy function, use the Router/Tally>Tally
Copy menu. The settings are common to the parallel and serial tallies.
To display the Tally Copy menu
In the Engineering Setup menu, select VF6 ‘Router/Tally’ and HF5 ‘Tally
Copy.’
The status area shows the tally copy status.
Making new tally copy settings
Use the following procedure.
1 In the Router/Tally>Tally Copy menu, select [New].
The New menu appears.
2 Turn the knob to select the copy-from source.
When setting more than one tally copy, you can specify the copy-from
source start and end addresses.
Knob Parameter Adjustment Setting values
1 Copy From (From) Copy-from source start address 1 to 1024