Chapter 16 Engineering Setup
346
Setup Relating to Router Interface and Tally
3
Specify the copy-to source address.
4
Press [Execute].
This makes the tally copy setting according to the specifications in steps 2
and 3.
Modifying tally copy settings
Use the following procedure.
1
In the Router/Tally>Tally Copy menu, press [Modify].
The Modify menu appears.
2
Use the knobs to select the copy source and copy destination.
3
Press [Execute].
This updates the tally copy settings.
Deleting tally copy settings
Use the following procedure.
1
In the Router/Tally>Tally Copy menu, using either of the following
methods, select the tally copy whose settings you want to delete.
• Press directly on the list appearing in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
2 Copy From (To) Copy-from source end address 1 to 1024
Knob Parameter Adjustment Setting values
Knob Parameter Adjustment Setting values
3 Copy To (From) Copy-to source (start) address 1 to 1024
4 Copy To (To) Copy-to source (end) address 1 to 1024
Knob Parameter Adjustment Setting values
1 Copy From Copy-from source 1 to 1024
2 Copy To Copy-to source 1 to 1024
Knob Parameter Adjustment Setting values
1 Copy No Tally copy setting selection for deletion 1 to ...
To Next Page
Loading...
