363File Batch Operations
Chapter 17 Files
Batch Loading Files
To load files from hard disk or memory card, use the following procedure.
1
In the device selection area of the ALL menu, select where the files are
held ([HDD] or [Memory Card] and directory). (See page 356.)
2
If there are files you do not want to load, in the <Category> group, exclude
them from the operation. To select all filed, press [ALL].
For details of the data to which operations apply, see “Files” in Chapter
1 (Volume 1).
3
Press the [T Load] button.
A confirmation message appears.
• Select “Yes” to carry out the batch load.
• Select “No” to cancel the batch load.
Batch Copying Files
To copy files between the hard disk and a memory card, use the following
procedure.
1
In the operating device selection section to the left of the ALL menu, select
the storage location ([HDD] or [Memory Card] and directory) of the
source files. (see page 356)
2
In the operating device selection section to the right of the ALL menu,
select the destination storage location ([HDD] or [Memory Card] and
directory). (see page 356)
3
If there are files you do not want to copy, remove them from the selection
in the <Category> group. To select all files, press [ALL].
For details of the data to which the operation applies, see “Files” in
Chapter 1 (Volume 1).
4
Press the [t Copy] button.
This copies the selected files to the specified destination.
If there is already data present in the destination location, a confirmation
message appears.
• Select “Yes” to overwrite.
• Select “No” to cancel copying all of the files.
To Next Page
Loading...
