63DME Special Effect Operations
Chapter 11 DME Operations
Nonlinear Effect Settings
You can add a variety of effects, including effects that change the shape of the
image as a whole. Use the following procedure.
1
In the DME menu, select VF4 ‘Non Linear’ and HF1 ‘Type.’
A menu for selecting the various effects appears.
2
Display the menu for the effect that you want to apply by pressing its
button.
The effect displayed is enabled.
3
Make the settings for the selected effect.
The following nonlinear effects are available.
Name Effect See
Wave Produces a wave-like effect in the image. page 64
Mosaic Glass Makes the image rougher and finer at a specified
interval.
page 69
Flag Applies an effect like a flag waving in the wind. page 69
Twist Twists the image. page 69
Ripple Applies an effect like ripples moving across the image. page 70
Rings Partitions the image into rings that rotate while moving
in the same direction.
page 75
Broken Glass Partitions the image like broken glass, with shards
flying outward.
page 76
Flying Bar Divides the image into bars which peel off in two blocks
as they move.
page 76
Blind Divides the image into bars or wedges, with blocks
rotating like the slats of venetian blinds.
page 76
Split Splits the image upper and lower, left and right. page 77
Split Slide Divides the image into bars which slide alternately in
reverse directions.
page 78
Mirror Partitions the image vertically and horizontally, creating
an image like a reflection in a mirror.
page 79
Multi Mirror Divides the image into originals and reflections, lining
them up vertically and horizontally.
page 80
Kaleidoscope Creates an image like a view into a kaleidoscope. page 80
Lens Creates an image like a view through a lens. page 81
Circle Makes a circle with the image. page 83
Panorama Curves the upper and lower edges of the image to
emphasize the sense of perspective.
page 83
To Next Page
Loading...
