81DME Special Effect Operations
Chapter 11 DME Operations
To apply the Kaleidoscope effect
With the Kaleidoscope menu displayed, set the following parameters.
To reflect the kaleidoscope image as if in a mirror
Use the following procedure.
1
To reflect in the horizontal direction, press [Mirror H], turning it on.
2
To reflect in the vertical direction, press [Mirror V], turning it on.
To set the reflection position
Use the following procedure.
1
Press [Position], turning it on.
2
Set the following parameters.
To cyclically repeat part of the original and its reflection
Press [Cyclic], turning it on.
Lens settings
The Lens effect creates an image like a view through a lens.
To apply the Lens effect
With the Lens menu displayed, use the following procedure.
1
In the <Mode> group, select the lens shape.
•Circle
• Rectangle
•Star
• Heart
•Bar
•Cross
Knob Parameter Adjustment Setting values
1 Number Number of blocks 0.00 to 100.00
2 Phase Angle of partition reference point –8.000 to +8.000
3 Offset H Amount of horizontal offset –4.000 to +4.000
4 Offset V Amount of vertical offset
–3.000 to +3.000
Knob Parameter Adjustment Setting values
1 H Horizontal reflection position
0.000 to 4.000
2 V Vertical reflection position
0.000 to 3.000
To Next Page
Loading...
