Sony DVS-9000SF - Multi Move Settings

47DME Special Effect Operations
Chapter 11 DME Operations
Masking the Blur effect with a selected pattern
Press [Mask] to display the Mask menu, and set the pattern type and modifiers.
For details, see “Mask Settings” (page 59).
Multi Move Settings
This effect shrinks the image and lines up a number of copies vertically and
horizontally.
For an illustrative figure and other information, see “DME Special Effects” in
Chapter 1 (Volume 1).
Applying the Multi Move effect
Use the following procedure.
1 In the DME menu, select VF2 ‘Video Modify’ and HF2 ‘Multi Move.’
The Multi Move menu appears.
2 Press [Multi Move], turning it on.
The Multi Move effect is enabled. You can adjust the center point of
shrinking, the ratio of shrinking, and the aspect ratio of the shrunken
images with the knobs.
3 Set the parameters.
The valid ranges of the parameter values depend on the aspect ratio (4:3/
16:9) selected in the system, as follows.
•4:3 mode
a) Specify minus values to stretch the image in the vertical direction, and plus values to
stretch the image in the horizontal direction.
Knob Parameter Adjustment Setting values
1 Center X x-value of shrinking center point –4.00 to +4.00
2 Center Y y-value of shrinking center point –3.00 to +3.00
3 Size Shrinking ratio 0.00 to 100.00
4 Aspect Aspect ratio of shrunken images
–100.00 to +100.00
a)