75DME Special Effect Operations
Chapter 11 DME Operations
Rings settings
The Rings effect partitions the image into rings that rotate while moving in the
same direction.
To apply the Rings effect
With the Rings menu displayed, use the following procedure.
1
To make transition settings, press [Transition] and set the following
parameters.
2
To set the partition method, press [Partition] and set the following
parameters.
3
To set the ring center position, press [Position] and set the following
parameters.
4
To partition into pixels, press [Pixel], turning it on, and set the following
parameters.
Knob Parameter Adjustment Setting values
1 Transition Degree of transition 0.000 to 100.000
2 Random Degree of randomness in distance
moved by each block
0.000 to 100.000
3 Spiral Amount of movement toward
periphery accompanying transition
–1.000 to +1.000
Knob Parameter Adjustment Setting values
1 Width Width of partition 0.000 to 100.000
2 Random Degree of randomness in partition
width
0.000 to 100.000
3 Angle Starting angle of effect –8.000 to +8.000
Knob Parameter Adjustment Setting values
1 H Horizontal center position –5.000 to +5.000
2 V Vertical center position –4.000 to +4.000
Knob Parameter Adjustment Setting values
1 Density Degree to which image disappears
around periphery
0.00 to 100.00
2 Random Degree of jaggies at block edges 0.00 to 100.00
To Next Page
Loading...
