77DME Special Effect Operations
Chapter 11 DME Operations
To apply the Blind effect
With the Blind menu displayed, use the following procedure.
1
In the <Mode> group, select [Bar] or [Wedge].
2
To make transition settings, press [Transition] and set the following
parameters.
3
To set the partition method, press [Partition] and set the following
parameters.
• When Bar was selected in step 2
• When Wedge was selected in step 2
To set the wedge center position
When Wedge is selected in the <Mode> group, you can set the wedge center
position.
1
Press [Position].
2
Set the following parameters.
Split settings
The Split effect splits the image upper and lower, left and right.
Knob Parameter Adjustment Setting values
1 Rotation Number of rotations of the blocks –8.000 to +8.000
2 Perspective Degree of randomness in distance
moved by each block
0.000 to 100.000
Knob Parameter Adjustment Setting values
1 Width Width of partition 0.000 to 100.000
2 Offset Degree of randomness in partition
width
–5.000 to +5.000
3 Angle Starting angle of effect –8.000 to +8.000
Knob Parameter Adjustment Setting values
4 No Width of blocks 0.000 to 100.000
5 Phase Partition position –8.000 to +8.000
Knob Parameter Adjustment Setting values
1 H Horizontal center position –8.000 to +8.000
2 V Vertical center position –6.000 to +6.000
To Next Page
Loading...
