Chapter 11 DME Operations
64
DME Special Effect Operations
Notes
• It is not possible to apply two or more nonlinear effects at the same time.
Turning any nonlinear effect on automatically turns all other nonlinear
effects off.
• The Flex Shadow function cannot be enabled when any of the nonlinear
effects Page Turn, Roll, Cylinder, and Sphere is enabled.
To turn an effect off
In the setting menu, press the button for the effect name, turning it off, or in the
Type menu press [OFF] in the lower right part of the window.
Wave settings
The Wave effect produces a wave-like effect in the image.
To apply the Wave effect
With the Wave menu displayed, use the following procedure.
1
In the <Mode> group, select the wave modulation mode.
H&V: Modulate vertically and horizontally without changing the size of
the image. This mode allows waves to be created in both the vertical
and horizontal directions at the same time.
SIZE: Create waves by reducing and expanding the image. This mode
allows waves to be created in one direction only.
Page Turn Turns the image like a turning page. page 83
Roll Rolls the image up. page 85
Cylinder Winds the whole image onto a cylinder. page 85
Sphere Winds the whole image onto a sphere. page 85
Explosion Divides the image into fragments which expand as they
fly out.
page 85
Swirl Swirls the image. page 87
Melt Melts the image away from a specified part. page 88
Character
Trail
Extends the edge of the image like a trail. page 89
Name Effect See
To Next Page
Loading...
