Sony DVS-9000SF - Page 70

Chapter 11 DME Operations
70
DME Special Effect Operations
a) Set when Lock is on.
b) Set when Lock is off.
To stop the waves
Press [Lock], turning it on.
With each press, the waves alternately stop and start moving again.
To select the waveform
Press [Form] and set the following parameters.
a) 1 (SINE): Sine wave
2 (PARABOLA): Parabola wave
3 (TRIANGLE): Triangular wave
4 (RECTANGLE): Rectangular wave
5 (CIRCLE): Circular wave
6 (CUBIC): Cubic wave
Ripple settings
Applies an effect like ripples moving across the image.
To apply the Ripple effect
With the Ripple menu displayed, use the following procedure.
Parameter group [1/2]
Knob Parameter Adjustment Setting values
1 Amp V Amplitude of twist in vertical direction 0.00 to 100.00
2 Freq V Frequency of twist in vertical direction 0.00 to 100.00
3
Offset V
a)
Amount of movement in twist phase
in the vertical direction
–16.00 to +16.00
4
Speed V
b)
Speed and direction of twist
movement in vertical direction
–100.00 to +100.00
5 Slant Slant of twist –8.000 to +8.000
Parameter group [2/2]
Knob Parameter Adjustment Setting values
1 Amp H Amplitude of twist in horizontal
direction
0.00 to 100.00
3
Offset H
a)
Amount of movement in twist phase
in the horizontal direction
–100.00 to +100.00
5 Slant Slant of twist –8.000 to +8.000
Knob Parameter Adjustment Setting values
1 Form H Waveform in horizontal direction
1 to 6
a)
2 Form V Waveform in vertical direction
1 to 6
a)