71DME Special Effect Operations
Chapter 11 DME Operations
1
In the <Mode> group, select the ripple modulation mode.
Radial: Points on radii of the same length from the center of the ripples
behave in the same way.
Angular: Points at the same angle from the center of the ripples behave in
the same way.
Both: Both Radial and Angular ripples are applied.
Shape: The ripples can have shapes such as stars or hearts in addition to
circles.
Modulation modes and directions
2
Set the following parameters, depending on the selected modulation mode.
• When Radial mode is selected
a) Set when Lock is on.
b) Set when Lock is off.
• When Angular mode is selected
Modulation along radii
(Radial mode)
Modulation along periphery
(Angular mode)
Knob Parameter Adjustment Setting values
1 Amp R Ripple amplitude along radius 0.00 to 100.00
2 Freq R Ripple frequency along radius 0.00 to 100.00
3
Offset R
a)
Direction along radius in which
to offset ripple phase and
amount of movement
–8.000 to +8.000
4
Speed R
b)
Ripple direction along radius
and speed
–100.00 to +100.00
5 Amp A Ripple amplitude along
periphery
0.00 to 100.00
Knob Parameter Adjustment Setting values
1 Amp A Ripple amplitude along periphery 0.00 to 100.00
2 Freq A Ripple frequency along periphery 0.00 to 100.00
To Next Page
Loading...
