Sony DVS-9000SF - Page 32

Chapter 11 DME Operations
32
DME Special Effect Operations
2 Press [Art Edge], turning it on.
This enables art edges, and you can now use the knobs to adjust the
parameters.
Note
The Defocus, Blur, Key Border, and Glow effects cannot be applied to the
Art Edge sections.
3 Set the parameters.
The valid ranges of the parameter values depend on the aspect ratio (4:3/
16:9) selected in the system, as follows.
•4:3 mode
• 16:9 mode
Parameter group [1/2]
Knob Parameter Adjustment Setting values
1 H Simultaneously adjust width of left
and right edges
Value of Left shown
2 V Simultaneously adjust width of top
and bottom edges
Value of Top shown
3 All Simultaneously adjust width of all
four edges
Value of Left shown
5 Density Density of edges 0.00 to 100.00
Parameter group [2/2]
Knob Parameter Adjustment Setting values
1 Top Width of top edge 0.00 to 6.00
2 Left Width of left edge 0.00 to 8.00
3 Right Width of right edge 0.00 to 8.00
4 Bottom Width of bottom edge 0.00 to 6.00
5 Density Density of edges 0.00 to 100.00
Parameter group [1/2]
Knob Parameter Adjustment Setting values
1 H Simultaneously adjust width of left
and right edges
Value of Left shown
2 V Simultaneously adjust width of top
and bottom edges
Value of Top shown
3 All Simultaneously adjust width of all
four edges
Value of Left shown