243Setup for the Whole System
Chapter 16 Engineering Setup
3
Press directly on the name of the software you want to license (the
Condition box is blank).
4
Press [License Management].
The License Management menu appears.
5
Press [Activate License].
A keyboard window appears.
6
Enter the 16-character install key you have been given, and press [Enter].
A license registration completed message appears.
7
Press [OK].
The status area Condition box shows “Active.”
8
Using either of the following methods, restart the device.
• In the System>Initialize menu, select only the device for which you
registered the license, and press [Reset] in the <Initialize> group.
• Power off and on again.
After restarting, the licensed software is now available for use.
(In case it becomes necessary to cancel the license registration, you can use the
following procedure.)
To cancel the license registration
Carry out the following procedure.
1
In the System>Install/Unit Config menu, use either of the following
methods to select the device for which you want to cancel the license
registration.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
2
Press [License].
The License menu appears.
To Next Page
Loading...
