395Color Corrector Functions
Chapter 19 Color Corrector
a) See “Positioner” under “Wipes” in Chapter 1 (Volume 1).
• When turning [Multi] on and replicating the same pattern
a) See “Pattern replication (“Multi”)” under “Wipes” in Chapter 1 (Volume 1),
• When turning [Aspect] on and setting the aspect ratio of the pattern
a) See “Aspect ratio” under “Wipes” in Chapter 1 (Volume 1).
• When turning the [Angle] on in the <Rotation> group and slanting
the pattern
a) See “Rotation” under “Wipes” in Chapter 1 (Volume 1).
• When turning [Speed] on in the <Rotation> group and rotating the
pattern at a fixed rate
a) See “Rotation” under “Wipes” in Chapter 1 (Volume 1).
6
To invert the mask source, return to the Primary CCR menu and press
[Mask Invert], turning it on.
Note
The mask function is common to the primary color correction, secondary color
correction, luminance processing, and spot color adjustment functions. For
example, if in primary color correction you set mask 1 to a box, then in
2 Position V Vertical position
–200.00 to +200.00
a)
Knob Parameter Adjustment Setting values
Knob Parameter Adjustment Setting values
1 H Multi Number of repetitions of pattern
horizontally
1 to 63
2 V Multi Number of repetitions of pattern
vertically
1 to 63
3 Invert Type Replication layout
1 to 4
a)
Knob Parameter Adjustment Setting values
1 Aspect aspect ratio
–100.00 to +100.00
a)
Knob Parameter Adjustment Setting values
1 Angle Angle of pattern rotation
–100.00 to +100.00
a)
Knob Parameter Adjustment Setting values
1 Speed Rotation rate of pattern
–100.00 to +100.00
a)
To Next Page
Loading...
