Chapter 16 Engineering Setup
288
Setup Relating to Operations From the Control Panel
To give audible feedback from menu touch screen operations: Press
[Touch Beep], turning it on.
Calibrating the touch panel
Use the following procedure.
1
In the Panel>Maintenance menu, press [Touch Panel Calibration].
The following message appears.
“To Perform Calibration, please touch the center of each plus sign.”
2
Press [OK].
3
Press the center of the plus sign displayed on the screen.
When you press on the plus sign, it disappears and a diagonally opposite
plus sign appears.
4
Press the center of the plus sign.
A confirmation message appears.
• Select “Yes” to restart the panel reflecting the new setting.
• Select “No” to cancel the setting and return to the Maintenance menu.
To Next Page
Loading...
