Chapter 16 Engineering Setup
302
Setup Relating to Switcher Processor
Settings for the show key function
Use the following procedure.
1
In the Switcher>Key/Wipe/FM menu, press [Show Key].
The Show Key menu appears.
2
In the <Show Key Enable> group, press the signal for which “show key”
is enabled, turning it on.
3
To set the time for which “show key” is held, press [Hold Time].
4
Adjust the following parameter.
Settings for DSK auto drop function
Use the following procedure.
1
In the Switcher>Key/Wipe/FM menu, press [DSK Auto Drop].
The DSK Auto Drop menu appears.
2
In the <DSK Auto Drop> group, press one of [DSK1] to [DSK4] for which
you want the DSK to be deleted automatically, turning it on.
Automatically naming and saving to frame memory
In the Switcher>Key/Wipe/FM menu, press [FM Auto Store], turning it on.
Selecting the bank to which the settings apply
For the section “Selecting the key memory mode” and subsequent sections,
select the operating bank to which the settings apply using any of the following
methods, then make the settings.
• Press directly on the list appearing in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
The selected bank appears in reverse video.
Knob Parameter Adjustment Setting values
1 Hold Time Show key hold time 0 to 999 (frames)
Knob Parameter Adjustment Setting
values
1 Bank M/E or P/P selection to which settings apply 1 to 4
To Next Page
Loading...
