303Setup Relating to Switcher Processor
Chapter 16 Engineering Setup
Selecting the key memory mode
In the <Key Memory> group of the Switcher>Key/Wipe/FM menu, select one
from Full (full mode)/Simple (simple mode)/Off.
For more details, see “Key Memory” in Chapter 1 (Volume 1).
Selecting the processing order of masks and borders
In the <Mask/Border Process> group of the Switcher>Key/Wipe/FM menu,
select one of the following.
Mask>Border: Apply the Mask effect, then apply the Border effect.
Border>Mask: Apply the Border effect, then apply the Mask effect.
Selecting the key priority operation mode
In the <Key Priority> group of the Switcher>Key/Wipe/FM menu, select one
of the following.
Normal: The key priority sequence can be varied freely.
Fix: Fixed at currently set priority sequence.
Setting the operation mode of the key bus [XPT HOLD] button
In the <Xpt Hold Mode> group of the Switcher>Key/Wipe/FM menu, select
any of the following.
Note
This setting is disabled for the CCP-9000.
Key Disable: The [XPT HOLD] button of the key bus functions as a key
disable button. When the [XPT HOLD] button is on, recalling a snapshot
or keyframe effect does not reflect the key settings, including the cross-
point selection information.
Xpt Hold: The [XPT HOLD] button of the key bus functions as a cross-point
hold button. When the [XPT HOLD] is on, recalling a snapshot or
keyframe effect does not reflect the cross-point selection information.
Setting the operation mode when the pattern limit is released
In the <Pattern Limit Transition> group of the Switcher>Key/Wipe/FM menu,
select either of the following operation modes.
Auto: When the pattern limit is released, the remainder of the transition is
carried out automatically at a special-purpose transition rate.
Manual: After the pattern limit is released, the transition waits for the next
operation, then executes. Until you move the fader lever or press [AUTO
TRANS], the transition is not executed.
To Next Page
Loading...
