Chapter 11 DME Operations
44
DME Special Effect Operations
2
Adjust the following parameters.
Notes
• The Combine Shadow effect is applied to all shadows, not only the
sections where shadows overlap.
• Combine Shadow is enabled when the Flex Shadow effect and the global
effect Combiner are enabled. In this state, Combine Shadow remains
enabled even if the global effect is disabled.
• In Combine Shadow, the settings for the channel with the lowest number
among the channels being combined are enabled.
Flex shadow creation example
The flow of flex pattern creation will be explained using the following pattern
as an example.
1
Press [Flex Shadow], turning it on.
2
In the <Flex Shadow> group, select [External].
3
Turn [Axis Loc] on and use knob 2 to set the Axis Loc V parameter so that
the center of the flex shadow deformation is at the bottom of the picture.
The following steps will be easier if you display the flex shadow axis
graphic by pressing [Flex Shadow Axis] in the Graphic menu.
Knob Parameter Adjustment Setting values
1 Density Density of combine shadow 0.00 to 100.00
To Next Page
Loading...
