Chapter 12 External Devices
142
Control of VTRs and Disk Recorders
• To set the stop point, press [SET] in the <Stop TC> group.
• To set the start delay time point, press [SET] in the <Delay> group.
A timecode window appears.
4
Set the timecode value for the start point, stop point, or start delay time.
Note
You can enter a start delay time in the range that depends on the signal
format as follows:
00:00 to 59:nn,
where nn = (number of frames per second) – 1.
5
Press [Enter].
The set start point, stop point, or start delay time is reflected in the status
area.
Clearing the start point, stop point, and start delay time settings
in a menu
In the Device menu, use the following procedure.
1
In the Device menu, press VF3 ‘DDR/VTR’ and HF1 ‘Cueup & Play.’
2
Using any of the following methods, select the device for which you want
to clear the settings.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
3
Carry out any of the following operations as required.
• To clear the start point, press [Clear] in the <Start TC> group.
• To clear the stop point, press [Clear] in the <Stop TC> group.
• To clear the start delay time, press [Clear] in the <Delay> group.
This clears the setting of the start point, stop point, or start delay time.
Knob Parameter Setting Setting values
1 Dev Device number 1 to 12
To Next Page
Loading...
