151Control of VTRs and Disk Recorders
Chapter 12 External Devices
• Turn the knob.
a) The range of setting values depends on the total number of files (maximum 5000).
4
Press [Load].
This recalls the selected file, and the file name appears at the top of the
status area.
Creating new files
A file name must be specified to record to a new file on a disk recorder.
Use the following procedure.
Note
New files cannot be created when the disk recorder is set to Player or Recorder/
Player.
1
In the Device menu, press VF3 ‘DDR/VTR’ and HF3 ‘File List.’
The Device>DDR/VTR>File List menu appears.
2
Press [New File].
The keyboard window appears.
3
Enter a file name and press [Enter].
When using the Sony disk recorder 9-pin protocol: Up to 23 characters.
When using the video disk communications protocol: Up to 8
characters
The name appears as the current file name at the top of the status area.
When the loaded file is not a target for recording
When a file that is not a target for recording is loaded in the disk recorder,
proceed as follows.
1
In the Device menu, press VF3 ‘DDR/VTR’ and HF3 ‘File List.’
The Device>DDR/VTR>File List menu appears.
2
Press [Unload].
The current file name at the top of the status area is cleared.
Knob Parameter Setting Setting values
2 No File selection
1 to 5000
a)
To Next Page
Loading...
