Chapter 13 Keyframe Effects
168
Creating and Editing Keyframes
3
Using image transformations or adding special effects, modify the
keyframe.
4
Press the [MOD] button.
This modifies the keyframe.
Modifying more than one keyframe simultaneously
You can modify a number of keyframes simultaneously. There are three
different cases for this operation.
• Modifying from the edit point to a particular keyframe
• Modifying all keyframes in the effect
• Modifying the keyframes in a specified range
The different procedures for these cases are now described.
To modify from the edit point to a particular keyframe
Use the following procedure.
1
Press the [EDIT ENBL] button, turning it on.
2
Stop the effect at the first keyframe of the range to be modified.
3
Carry out the necessary modifications.
4
Press the [FROM TO] button, turning it on.
The display in the numeric keypad control block shows the current
keyframe number, followed by “TO.”
5
Enter the number of the last keyframe to be modified from the numeric
keypad control block and press the [ENTER] button to confirm.
6
Press the [MOD] button. Alternatively, hold down the [SHIFT] button and
press the [MOD] button.
For the difference in the result, see “Differences in the changes when a
number of keyframes are modified” (page 169).
This makes the modification simultaneously to all keyframes from the edit
point to the specified keyframe.
To modify the keyframes in a specified range
Use the following procedure.
To Next Page
Loading...
