241Setup for the Whole System
Chapter 16 Engineering Setup
4
To carry out installation, press [Execute].
A confirmation message appears.
5
Select [Yes].
This installs the software.
Displaying installation details
In the System>Install/Unit Config menu, press [Detail Information].
This accesses the Detail Information menu, and displays the detailed
information on the software and firmware installed in the currently selected
device.
Making settings required to use the software
To use the software listed above, you are required to enter an install key which
validates the software. (If the software has been factory installed, the install key
is not required.)
For the method of obtaining an install key, contact your Sony representative.
To obtain a key, you may be required to submit the unique device ID of the
switcher you are using. You can check the unique device ID in the Install/Unit
Config menu of the switcher, using the following procedure.
To display the unique device ID
To check the unique device ID, carry out the following procedure.
1
In the System>Install/Unit Config menu, use either of the following
methods to select the device for which you want to register the license.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
2
Press [License].
The License menu appears as follows.
BZS-9250 Simple P/P software
BZS-9420 Color corrector software
BZS-9471 Texture lighting software (for BKDS-9470)
BZDM-9050 Texture lighting software (for MVE-9000)
To Next Page
Loading...
