Chapter 16 Engineering Setup
278
Setup Relating to Operations From the Control Panel
6
Press [Action Set] to confirm the action selection.
The selected setting appears in the status area.
Carrying out level settings
To set the low level and high level, first set the trigger type to “Level,” then use
the following procedure.
1
In the Panel>Device Interface menu, select the action to be set, and press
[H/L Set].
The H/L Set menu appears.
2
Using any of the following methods, select the settings.
• Press directly on the list appearing in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
3
To apply the selection made in step 2 when the input is the GPI high level,
press [H Set]. To apply the selection made in step 2 when the input is low,
press [L Set].
This confirms the setting, which appears in the status area.
Making control panel GPI output settings
Use the following procedure.
1
In the Panel>Device Interface menu, press [GPI Output].
The GPI Output menu appears.
2
Using any of the following methods, select the settings.
• Press directly on the list appearing in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
Knob Parameter Adjustment Setting values
1 No Signal format/screen
aspect ratio selection
1 to ...
Knob Parameter Adjustment Setting values
1 Port No Port selection 1 to 8
To Next Page
Loading...
