Chapter 16 Engineering Setup
298
Setup Relating to Switcher Processor
a) Adjustable for Box2
5
When in step 3 you selected [Box1] or [Box2], in the <Box1 Adjust> or
<Box2 Adjust> group, select the aspect ratio (16:9/14:9/4:3).
Setting the reference output
To adjust the reference output phase with respect to the reference input, adjust
the following parameters in the Switcher>Output menu.
Cropping the image to a 4:3 aspect ratio in an HD system
In an HD system, to crop an image having a screen aspect ratio of 4:3 to an
aspect ratio of 4:3, use the following procedure.
Note
This setting is disabled for the DVS-9000 system.
1
In the Output menu, press [4:3 Crop].
The Output 4:3 Crop menu appears.
The status area shows the output ports and respective 4:3 Crop mode
settings.
2
Using any of the following methods, select the output port.
• Press directly on the list appearing in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
a) Depends on what processor output boards are installed.
3
Press [4:3 Crop], turning it on.
This enables the crop setting, and this is reflected in the status area.
Note
When the screen aspect ratio of 16:9 is selected for all M/E banks in the
System>Format>Active Line/Aspect menu, the setting of 4:3 Crop is disabled.
Knob Parameter Adjustment Setting values
2 Line Line phase –90 to +90
3 Time Time –32.00 to +96.00
Knob Parameter Adjustment Setting values
1 Output No Output port to which setting applies
1 to 48
a)
To Next Page
Loading...
