305Setup Relating to Switcher Processor
Chapter 16 Engineering Setup
4
In the <Bus Select> group, select [Master Bus] (link source bus).
5
Using any of the following methods, select the bus to be the link source,
and press [Bus Set].
• Press directly on the list appearing in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
a) Only when [Master Bus] is selected, 171 (M/E-1 Trans PGM), 172 (M/E-2 Trans PGM),
173 (M/E-3 Trans PGM), and 174 (P/P Trans PGM) are available. When [Linked Bus] is
selected, 172 to 174 are not available.
Only when [Linked Bus] is selected, 103 (AUX1 as key) to 150 (AUX48 as key), and 159
(MON1 as key) to 166 (MON8 as key) are available. When [Master Bus] is selected, 103
to 150 and 159 to 166 are not available.
Note
With one of 171 to 174 selected for [Master Bus], linking is carried out
as soon as you start moving the fader lever.
6
In the <Bus Select> group, select [Linked Bus] (link destination bus).
7
Referring to step 5, select the bus to be the link destination, and press [Bus
Set].
8
Turn the knob to select the link table, and press [Link Table Set].
For more information about link tables, see the following item.
The status area reflects the current setting status.
To delete a link
Select the link you want to delete, then press [Clear] in the Internal Bus Link
menu.
Making link table settings
Use the following procedure.
1
In the Internal Bus Link menu, press [Link Table Select].
The Link Table Select menu appears.
Knob Parameter Adjustment Setting values
2 No Bus selection
1 to 174
a)
Knob Parameter Adjustment Setting values
3 Link Table No Link table selection 1 to 8
To Next Page
Loading...
