Chapter 16 Engineering Setup
332
Setup Relating to DCU
a) The setting value range depends on the DCU port setting.
3
Using any of the following methods, select the protocol for the connected
device.
• Press directly on the list on the right of the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
a) 1. No Assign: nothing is connected to the serial port.
2. P-Bus: P-Bus device.
3. VTR: VTR
4. DDR SD9P: disk recorder (Sony disk 9-pin protocol)
5. DDR VDCP: disk recorder (video disk communication protocol)
4
Press [Device Type Set].
The selected protocol is reflected on the left of the status area.
5
To enter the name of the serial port, press [Set] in the <Name> group.
A keyboard window appears. You can enter a name of not more than 16
characters.
If no name is set for the serial port, it is displayed as “DCUd_PORTs-p.”
d: 1 or 2 (DCU No.)
s: 1 to 5 (Slot No.)
p: 1 to 6 (Port No.)
6
Press [Enter].
To return the set name to the default name
Press [Clear] in the <Name> group.
7
From the <SCU Select> group, select the control panel (SCU1, SCU2 or
SCU3) assigned to operations on the external device connected to the
serial port.
To delete the serial port assignment
Use the following procedure.
1
In the DCU>Serial Port Assign menu, select the target for the setting
(DCU1 or DCU2) from the <DCU Select> group.
Knob Parameter Adjustment Setting values
1 Port No Serial port
1 to max.
a)
Knob Parameter Adjustment Setting values
2 Device Type Protocol selection
1 to 5
a)
To Next Page
Loading...
