Sony DVS-9000SF - Page 378

Chapter 18 Macros
378
Macro Operations in the Numeric Keypad Control Block and the Keyframe Control Block
• To move to an edit point by specifying an event number (the number
showing the position of the event in the macro execution sequence),
press the [GO TO KF] button in the keyframe control block, then in the
numeric keypad control block, enter the target number and confirm with
the [ENTER] button.
Inserting an event
Use the following procedure.
1 Specify the edit point. (See page 377.)
2 If required, press the [AUTO INS] button assigned to a utility/shotbox
control block or user preference button, to toggle the auto insert mode on
or off.
3 Create the event.
• When auto insert mode (see page 375) is on, the event is automatically
added to the macro.
• When auto insert mode is off, proceed to step 4.
4 When auto insert mode is off, press the [INS] button in the keyframe
control block.
5 Repeat steps 3 and 4 to insert the required events in the macro.
Modifying a single event
Use the following procedure.
1 Specify the edit point. (See page 377.)
2 When the [AUTO INS] button assigned to a utility/shotbox control block
button or user preference button is lit, press this to turn the auto insert mode
off.
3 Create the event.
4 Press the [MOD] button in the keyframe control block.
Modifying a particular range of events
Use the following procedure.
1 Carry out steps 1 to 3 of the procedure in “Modifying a single event” (the
previous item).