Sony DVS-9000SF - Page 449

449Error Messages
Appendix
Icon Title Message Description
Activate
License
The license key you entered is
invalid.
Please check and enter again.
7316.7: Engineering Setup>System>Install/Unit
Config>License>License Management
In the above menu, since the entered
information was incorrect, the Activate License
procedure failed. Check the license key, and
enter again.
Activate
License
License key was successfully
entered.
The license will be activated
after rebooting your system.
7316.7: Engineering Setup>System>Install/Unit
Config>License>License Management
In the above menu, the Activate License
procedure completed successfully.
Deactivate
License
The license will be deactivated
after rebooting your system.
7316.7: Engineering Setup>System>Install/Unit
Config>License>License Management
In the above menu, the Deactivate License
procedure completed successfully.
Disk
Format
Success!! 7317: Engineering Setup>System>
Maintenance
In the above menu, removable disk formatting
procedure completed successfully.
Failure.
Make sure of the memory card.
7317: Engineering Setup>System>
Maintenance
In the above menu, removable disk formatting
procedure failed. Check that the memory card
is correctly inserted.
Error This operation is cancelled,
because the register is locked.
Please change the register
status to be unlocked first.
6211.1: Effect>Master Timeline>Store>Edit
6311.1: Snapshot>Master Snapshot>Store>
Edit
6411.1: Shotbox>Register>Store/Recall>Edit
In the above menu, an attempt was made to
assign to a register that is locked. Unlock the
register before carrying out the assignment.
Failed... 7162: File>All, External File>Import/Export
In the above menu, importing a file failed.
Check the format of the original file, and try
again.
File Open
Status
ERROR (01) 533X: Device>DDR/VTR menu
When an error is returned from the DDR/VTR,
one of these messages appears, depending on
the error number.
Use menu 7355: Engineering Setup>DCU>
Serial Port Assign or menu 7325.4:
Engineering Setup>Panel>Device Interface>
Serial Port Assign to check the device settings.
ERROR (02)
ERROR (FF): No target device
has been assigned