73DME Special Effect Operations
Chapter 11 DME Operations
a) Set when Lock is on.
b) Set when Lock is off.
c) 1 (Circle): Circle
2 (Rectangle): Rectangle
3 (Star): Star
4 (Heart): Heart
To limit the direction in which modulation is applied
By pressing [Plus Only], turning it on, you can limit the direction in which
modulation is applied (the direction in which the image expands) to the plus
direction only.
To set the ripple center point
Use the following procedure.
1
Press [Position], turning it on.
2
Set the following parameters, depending on the selected modulation mode.
• When Shape is selected
• When other than Shape is selected
To limit the ripple range
1
Press [Range], turning it on.
Parameter group [2/2]
Knob Parameter Adjustment Setting values
1 Aspect Ripple aspect ratio –100.00 to +100.00
2 Angle Ripple angle –8.000 to +8.000
Knob Parameter Adjustment Setting values
1 H Ripple center point in
horizontal direction
–5.000 to +5.000
2 V Ripple center point in vertical
direction
–3.000 to +3.000
Knob Parameter Adjustment Setting values
1 H Ripple center point in
horizontal direction
–8.000 to +8.000
2 V Ripple center point in vertical
direction
–6.000 to +6.000
To Next Page
Loading...
