Starcraft SOLO - Page 50

50
(7) Click on the CREATE icon to open the Cut Settings window. Click on the Print+Cut icon in the lower left
corner:
(8) The Print and Cut window will open:
(9) Click on Print and mark the box next to Print Registration Marks. Click on OK to print the project:
Click on
Print+Cut
1. Instructions to
use as needed
2. Click Print to
print the project
3. Make changes
to
Cut Settings
,
as needed
4. Click on Next
Print area based on your
printer’s current settings
Four reg marks surround
the design to be printed