NOTE
●
The system is active only if the industrial
truck moves under guidance
●
Once the industrial truck is switched off, the
system goes into a rest position after a
short time. Reactions in the load wheel axle
can be felt by the operator
●
The system is fully automatic. The operator
has no influence over the functions
●
The parameterising of this function is based
on on-site measurements. If the conditions
change compared with these measure-
ments, correct functionality can no longer
be guaranteed
Error messages
Error message
In the event of a fault or defect, one or more
numbers appear led by a pictogram of a warn-
ing triangle. Call the authorised service centre
and provide the authorised service centre with
these numbers.
NOTE
See also the section entitled "Operating in-
structions".
Possible cause
●
Defect in the sensor system
●
Defect in the mechanism
Effect
●
Lift height of less than 3 m -> speed limita-
tion to 1 km/h
●
Lift height of over 3 m -> drive stop, bridg-
ing not possible
Remedy
Call the authorised service centre.
Special equipment
7
Automatic Floor Compensation AFC
1195231 804 2502 EN - 04/2020
To Next Page
Loading...
