Protective roof cover
The standard overhead guard meets the cur-
rent standards in terms of stability and the dis-
tance between the roof struts. However, if
heavy objects that are small enough to fit
through the roof struts of the overhead guard
are transported in a storage area, there is a
danger that if they fall from a considerable
height, they may fall through the overhead
guard and injure the operator. To prevent this
danger, a cover made of high-strength plastic
can be fitted to the overhead guard at the fac-
tory.
NOTE
The protective roof cover must always be
clean so as not to obstruct the view upwards.
●
Clean regularly.
●
Use cleaning materials that are suitable for
plastics.
●
Replace defective protective roof covers im-
mediately.
Radio installation
Industrial trucks can be
prepared
in the facto-
ry for the installation of a car radio (1).
The preparation consists of:
●
Console underneath the overhead guard
with two built-in loudspeakers.
●
Standard installation slot for the installation
of commercially available car radios
●
Rod antenna on the overhead guard
●
12 V voltage transformer
CAUTION
Risk of accident
The operator's attention may be limited by sound
from a radio or playback device, especially if the vol-
ume is particularly loud.
The use of sound devices is allowed only if permitted
or tolerated by the responsible operating company.
Special equipment
7
Protective roof cover
1435231 804 2502 EN - 04/2020
To Next Page
Loading...
